How do I reset my brother hl 2130 drum unit?

How to reset the drum counter:

1. Make sure the machine is on, then open the front cover.
2. Press and hold the “Go” button for about 4 seconds or until all the LEDs light up.
3. Release the “Go” button and close the front cover.
4. If the drum light is off, the drum unit is reset.

Why is drum light on Brother printer?

The Drum LED flashes if the drum unit is near the end of its life. Use the drum unit until you have a print quality problem, then replace the drum unit with a new one. The Drum LED continues to flash if the drum counter was not reset when you installed a new drum unit.

How do you reset the drum on a Brother HL?

Once the new drum is replaced, you will need to reset the drum counter on the Brother HL-L2350DW:

1. Make sure the machine is on.
2. Close up the front cover.
3. Hold down the “OK” button and the “up” arrow at the same time.
4. Press the “OK” button to select “Drum”.
5. Select the “down” button to reset the drum counter.

Why does my Brother printer keep saying drum error?

Drum Error typically appears when the corona wire on the drum unit needs to be cleaned or when the drum unit needs to be replaced. If you replaced the drum and the message appeared or continued to appear immediately after installing the replacement drum, click here.

How do you reset the drum on a 2240 HL?

How do you reset the drum on a Brother HL 2240?

How do I reset my printer after replacing drums?

Press the UP OR DOWN ARROW key to select Reset Parts Life. Press OK. NOTE: If Reset Parts Life is not an option, this means ‘Replace Drum’ or ‘Drum Stop’ is not on currently displayed on the LCD. The option is only available when machine has the ‘Replace Drum’ or ‘Drum Stop’ message.

How do you reset the drum counter on a Brother HL 2280DW?

DCP-7060D, DCP-7065, HL-2280DW,

1. Turn on the printer and replace the drum. Keep the front door open.
2. Press the Clear button.
3. Press the Arrow Up button.
4. When the screen says Accepted, close the front door.
5. The drum unit is reset.

How do you fix a Brother drum error?

Drum Error (Drum!)

1. The corona wires have become dirty. Clean the corona wires in the drum unit.
2. The drum unit or the toner cartridge and drum unit assembly is not installed correctly. Reinstall the toner cartridge and drum unit assembly.
3. If the issue still continues, the drum unit is at the end of its life.

How do you fix a printer drum error?

How do I factory reset my Brother printer?

Unplug all the interface cables before you perform a Factory Reset.

1. Press the Up or Down arrow key to select Initial Setup, and then press OK.
2. Press the Up or Down arrow key to select Reset, and then press OK.
3. Press the Up or Down arrow key to select Factory Reset, and then press OK.